After receiving an approved ATF Form 1, you must legally mark your firearm with “NFA markings” which may be your full name, city, and state (in the case of individual filings) or the name of your NFA trust, city, and state (in the case of trust filings). These markings have very specific ATF-mandated requirements, and Lemcoe Precision has the equipment and expertise to properly mark your newly-approved SBR or SBS. The majority of NFA engraving is done on a fiber laser machine, as a typical CO2 laser is not sufficient to engrave aluminum or steel.

We have a variety of places we can engrave your Form 1 information, give us a call or schedule an appointment to get a quote.

According to the ATF’s NFA Handbook:

(1) By engraving, casting, stamping (impressing), or otherwise conspicuously placing or causing to be engraved, cast, stamped (impressed) or placed on the frame or receiver thereof an individual serial number. The serial number must be placed in a manner not susceptible of being readily obliterated, altered, or removed, and must not duplicate any serial number placed by you on any other firearm. For firearms manufactured, imported, or made on and after January 30, 2002, the engraving, casting, or stamping (impressing) of the serial number must be to a minimum depth of .003 inch and in a print size no smaller than 1/16 inch; and

(2) By engraving, casting, stamping (impressing), or otherwise conspicuously placing or causing to be engraved, cast, stamped (impressed), or placed on the frame, receiver, or barrel thereof certain additional information. This information must be placed in a manner not susceptible of being readily obliterated, altered or removed. For firearms manufactured, imported, or made on and after January 30, 2002, the engraving, casting, or stamping (impressing) of this information must be to a minimum depth of .003 inch. The additional information includes: